Need to join two pipes and don’t know how? You don’t need an adapter; there are other ways to do it effortlessly. Here are 4 foolproof tips for connecting two pipes without using an adapter!
methods for joining pipes
Connecting two hoses without an adapter is easy; just use one of the many effective and easy-to-use methods to achieve this goal. Here are four tips for connecting two hoses without an adapter and saving a lot of money!
First tip for joining two pipes
The first trick to connect two pipes without an adapter involves using cutters , here’s how to do it:
Using cookie cutters, cut the tube in half;
Cut a piece of pipe in half again;
Using the hair dryer, blow hot air on the end of a piece of tubing;
While it is still soft, insert the other piece of tubing;
Slide the one where you used the hair dryer a few inches;
You can stop when you realize it’s stuck;
When it hardens, remove it and apply glue to the end;
Replace the tube, let it dry and then cut it in the center of the joint;
Repeat on the other side of the tube then cut;
Finally, file the ends on the sandpaper.
Seal the ends of the pipes with a piece of wire . The adapter for joining two pipes is ready, you can insert them from both sides and they are ready to use.
Joining tubes
Second tip
This second trick involves joining the two ends of a garden hose. Both ends are identical, so you’ll need a piece of hose to join them . Here’s how to do it:
Take a round steel screw joint;
Heat it over high heat;
Pick it up with tongs and place it on a suitable surface;
While still hot, insert a piece of plastic tubing 3/4 of the way in;
Place the piece of vine in water to cool;
When it is cold, unscrew the bolt from the plastic tube using pliers;
The tube will have the same grooves as the bolt at its end;
Heat the bolt again and repeat the process with the other end of the pipe.
At this point, cut off the piece that protrudes from the groove , place gaskets on the ends of the irrigation pipes and screw the piece of pipe onto both. The water will not come out and the connection will be perfect.
Third tip for joining two tubes
Is your irrigation hose leaking because there’s a hole in it? Here’s how to get it working again and avoid buying another one . Here’s how:
Cut the pipe where the leak is located;
Cut a piece of rigid pipe the size of the irrigation pipe;
Apply some clear glue and insert the rigid piece inside the irrigation pipe;
Do the same with the other side;
Seal both ends with a plastic tie and pull the closure tightly;
Cut off the excess parts.
The irrigation pipe is now ready for operation again without the risk of water leakage.
Connecting the pipes
Fourth tip
If the irrigation pipe is leaking because it is cracked, you can solve the problem in this way: Cut the pipe where there is a crack from which water is leaking;
Insert a piece of plastic into the two ends that connect the two sides;
On the outside, screw the two parts supplied in the packaging, each equipped with two screws;
Screw both firmly until the inserted part feels secure.
You have now joined the two parts of the irrigation hose and the water will no longer flow. You will be able to use the hose for irrigation without any problems and as you can see, you have repaired the hose without purchasing the adapter .
With these four tips, you can connect any pipe easily and in just a few minutes, saving you the hassle of buying an adapter and therefore spending more money. You can choose one of the tips described depending on the pipe you need to connect.